Agricultural laboratories use Kjeldahl nitrogen for two quite different measurements: total nitrogen in soil and organic material, and nitrogen content in fertilisers. The chemistry is the same; the sample weights, digestion conditions and reporting units are not, and treating them as one method is the most common source of irreproducible results.
This article sets out how the method is applied to those matrices in practice. It is written by the engineering team at HENG MEI Intelligent Manufacturing for soil, fertiliser and agricultural testing laboratories.
Two different jobs, one chemistry
| Matrix | Typical nitrogen level | Sample weight implication | Reported as |
|---|---|---|---|
| Mineral soil | 0.05–0.3% | Large sample needed to reach the detection window | % N, or g/kg |
| Organic soil, compost | 0.5–2% | Moderate weight | % N, C/N ratio with organic carbon |
| Organic fertiliser, manure | 1–5% | Small weight; homogeneity is the challenge | % N |
| Mineral fertiliser (urea, ammonium salts) | 20–46% | Very small weight; weighing accuracy dominates | % N |
The analyser's working range — 0.1 to 240 mg nitrogen in the HM-DN2 — is wide enough for all four. The constraint is the sample-weight limit of about 8 g of solid, which caps how much nitrogen can be loaded from a low-nitrogen soil. A soil with 0.05% N and an 8 g sample delivers 4 mg of nitrogen, comfortably inside the range; a soil with 0.01% N at the same weight delivers 0.8 mg, near the lower end where duplicate agreement deteriorates.
Digestion is where agricultural samples differ
Soil and organic materials are harder to digest than food. Three practical adjustments follow.
- Catalyst and salt ratio. A sulphate catalyst mixture accelerates digestion; the ratio of salt to acid determines the boiling point and therefore the completeness of digestion.
- Nitrate and ammonium. Soils may contain nitrate, which is not recovered by a simple Kjeldahl digestion unless a reduction step (salicylic acid or Devarda alloy) is included. Laboratories should confirm whether their method requires nitrate inclusion.
- Foaming and bumping. Organic matter and carbonates cause foaming in the digestion tube; a slow initial temperature ramp reduces losses.
A digestion that is incomplete produces a result that is precise and wrong — duplicates agree with each other because both were equally incomplete. Recovery checks with a standard, run alongside each batch, are the only way to detect it.
Duplicate practice and the 0.5% claim
Analyser specifications quote repeatability as parallel difference ≤0.5%, which is agreement between duplicate determinations of the same sample. In agricultural work, that figure is dominated by sample heterogeneity rather than instrument precision.
A soil sample ground to pass a 0.15 mm sieve and mixed thoroughly will give duplicates within specification. The same soil ground coarsely, or a manure sample with visible straw, will not — and the result will be blamed on the instrument. Laboratories should treat grinding and mixing as part of the analytical method, with a stated procedure, not as preparation done by whoever is free.
Where the method is used beyond total nitrogen
Kjeldahl chemistry also serves soil cation exchange capacity determination under LY/T 1243, where ammonium is displaced and then measured as nitrogen. Laboratories offering that test can use the same analyser, changing only the extraction step. It is worth confirming with the instrument supplier that the range and sample volume suit the extract concentrations involved, which are often lower than in a direct soil digest.
Instrument configuration for agricultural workloads
The instrument logic for this work — full automation of reagent addition, distillation, absorption and titration, and the choice between static and dynamic titration modes — is set out in our Kjeldahl analyser guide. For an agricultural laboratory, three questions usually decide the configuration.
- How many samples a day, including duplicates? Duplicates double the effective count; a 40-sample day is 80 determinations.
- Is nitrate inclusion required? That changes the digestion protocol and may change the sample weight.
- Is cation exchange capacity offered? If so, confirm the analyser handles the lower nitrogen concentrations in those extracts.
HENG MEI Intelligent Manufacturing supplies automatic Kjeldahl analysers with full reagent and titration automation, alongside block digestors and the consumables the method requires, so an agricultural laboratory can specify the complete path from sample to result rather than the analyser alone.
To plan a configuration, tell our sales contact the matrices, the samples per day including duplicates, whether nitrate is included and which standards you report against.
Contact: Grace, Sales Contact, graceliu@hmdzkj.cn, +86 17853698681 (Tel / WhatsApp / WeChat).
Article address:https://www.labinstruments.net/news/kjeldahl-nitrogen-soil-fertiliser-testing.html

